Your position: Home > Arduino > Shields

Kuman Ethernet Shield W5100 Micro-sd Card Slot for Arduino 2009 UNO Mega 1280 Mega 2560 Nano Duemilanove K15

Item Code: K15
Price:
USD
$11.90
Shipping Cost:
to
Delivery:
Estimated between
Units
  • Description
Key Features:
● Direct plug puzzle board, NO soldering needed
● Supports reading and writing mini SD / TF card
● Brand new ethernet shield with wiznet W5100 ethernet chip
● The Ethernet W5100 network expansion module allows the to be a simple Web server
● With Micro SD card slot, supports SD card up to 2GB, supports 2009, UNO, mega 1280, mega 2560, Nano, Duemilanove

Detailed information:

This Ethernet Shield for Arduino allows board to connect to the internet.
It is based on the Wiznet W5100 ethernet chip.
The Wiznet W5100 provides a network (IP) stack capable of both TCP and UDP.
It supports up to four simultaneous socket connections.
Use the Ethernet library to write sketches which connect to the internet using the shield.
The new Ethernet shield now includes a micro SD card connector, it is MEGA compatible and an on-board reset controller.
The ethernet shield connects to board using long wire-wrap headers which extend through the shield. This keeps the pin layout intact and allows another shield to be stacked on top. uses digital pins 10, 11, 12, and 13 (SPI) to communicate with the W5100 on the ethernet shield.
These pins cannot be used for general i/o.
Can be used as server or client. -Directly plug puzzle board, no soldering required. -Based on the Wiznet W5100 Ethernet Chip.
This is the latest version of the Ethernet Shield.
Directly supported by official Ethernet Library.
Adds a micro-SD card slot, which can be used to store files for serving over the network.
Compatible with the Duemilanove (168 or 328), Uno as well as Mega (1280/2560) and can be accessed . Using the SD library.
MAC address: 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED byte mac[] = { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED };
Direct plug puzzle board, NO soldering needed
Supports reading and writing mini SD / TF card
Brand new ethernet shield with wiznet W5100 ethernet chip
The Ethernet W5100 network expansion module allows the to be a simple Web server
With Micro SD card slot, supports SD card up to 2GB, supports 2009, UNO, mega 1280, mega 2560, Nano, Duemilanove
Customer Reviews
Recent Reviews
  • ByGreg P
  • Nov 19, 2016
Cheaper versions out there but too many bad reviews for them. Got this one because it works. Solder job good. Two boards from them so far.

  • Byory
  • Nov 19, 2016
Works without a problem with an Arduino clone. I'm currently using it as part of a MySensors MQTT gateway, and have had absolutely no issue with it for the last week.

  • ByStephe Koontz
  • Oct 15, 2016
Easy to setup and got it working in a few minutes with the default auduino ethernet shield sketch. Adafruit has great tutorials on using these. I have mine setup as a webserver, where I can check the status of my home automation system from my phone. Networking can be complicated and the review that says it cannot "be found by the router" is just silly, the router doesn't find devices, the devices find the router/gateway! As long as you have an even basic understanding of networking, this shield works perfectly fine and is a really good price!